LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Hydraulic Brakes) >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the reservoir for cracks or deformation. If found, replace the reservoir.
  2. Clean the reservoir with denatured alcohol, or equivalent.
  3. Dry the reservoir with non-lubricated, filtered air.
  4. Lubricate the new seals and the outer surface area of the reservoir-to-housing barrels with Delco Supreme 11®, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid, from a clean, sealed brake fluid container.
  5. Install the lubricated seals, make sure they are fully seated.
  6. Install the reservoir to the master cylinder by pressing the reservoir straight down on the master cylinder until the pin holes are aligned.
  7. Carefully install the reservoir retaining pins to secure the reservoir.
  8. Place the brake fluid level sensor into the reservoir, press into place to secure the sensor retaining tabs.
  9. Remove the master cylinder from the vice.
  10. Install the master cylinder. Refer to Master Cylinder Replacement (Vacuum Boost)  or Master Cylinder Replacement (Hydraulic Boost)  .
  11. Release the park brake
  12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure)  .
scientia non olet · About LEMON Manuals