LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Hydraulic Brakes) >> Repair Instructions >> Brake Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bend the brake pipe to achieve proper fit.
  2. Install the brake pipe to the vehicle. Maintain a clearance of 19 mm (3/4 in) for all moving or vibrating components.
  3. Install the brake pipe fasteners to the vehicle.
  4. Connect the brake pipe fittings.
    • Tighten the brake pipe fittings to the BPMV or the wheel jounce hoses to 25 N.m (18 lb ft).
    • Tighten the brake pipe fittings to the master cylinder to 25 N.m (18 lb ft).
  5. Bleed the hydraulic brake system. Refer to ABS AUTOMATED BLEED PROCEDURE .
scientia non olet · About LEMON Manuals