LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Hydraulic Brakes) >> Repair Instructions >> Brake Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal.
  2. Install the brake pedal bolt.
  3. Install the nut to the brake pedal bolt. Hold the nut with a wrench and tighten the brake pedal bolt to 47 N.m (35 lb ft).
  4. Install the pushrod (3) and the stoplamp switch (2) to the brake pedal pin (1).
  5. Install the pushrod retaining clip (4).
scientia non olet · About LEMON Manuals