Transaxle Mount Assembly (Side): Installation
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Transfer the rear upper mount to the new mount. Position the mount and start the rear upper bolt into the threads. Install the remaining 3 bolts. Tighten all 4 of the mount bolts to specification. See TORQUE SPECIFICATIONS .
- Install the mount-through bolt. Tighten the mount-through bolt to specification. See TORQUE SPECIFICATIONS .
- Remove the jackstand and the wood block. Install the left splash shield.
- Install the left tire and wheel assembly. Lower the vehicle.