LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Entertainment System) >> Repair Instructions >> Speaker Replacement - Rear Door >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Door Speaker
    GM799001Courtesy of GENERAL MOTORS CORP.
  1. Install the speaker mounting bracket.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the bolts (2) retaining the speaker mounting bracket to the door, if removed.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

  3. Install the speaker to the mounting bracket.
  4. Connect the electrical connector to the speaker.
  5. Install the screws (1) that retain the speaker to the mounting bracket.

    Tighten:  Tighten the screws to 2 N.m (53 lb in).

  6. Install the door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE REAR DOOR (TAHOE/YUKON/ESCALADE) or TRIM PANEL REPLACEMENT - SIDE REAR DOOR (SUBURBAN/YUKON XL/AVALANCHE/ESCLD EXT) .
  7. Verify the component operation.
scientia non olet · About LEMON Manuals