Remote Playback Device Inoperative
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Remote Playback Device Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Radio/Audio System Schematics | |||
| 1 | Did you review the Radio/Audio System Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Radio/Audio System Description and Operation |
| 2 |
|
Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS | Go to Step 3 |
| 3 |
|
Go to Step 10 | Go to Step 4 |
| 4 | Test the ground circuit of the remote playback device for high resistance or an open. Refer to CIRCUIT TESTING
andWIRING REPAIRS
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 5 |
| 5 | Test the radio on signal circuit of the remote playback device for a short to ground or an open. Refer to CIRCUIT TESTING
andWIRING REPAIRS
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 6 |
| 6 | Test the entertainment and comfort serial data circuit of the remote playback device for a short, high resistance, or an open. Refer to CIRCUIT TESTING
andWIRING REPAIRS
. Did you find and correct the condition? |
Go to Step 10 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the remote playback device. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS
and CONNECTOR REPAIRS
. Did you find and correct the condition. |
Go to Step 10 | Go to Step 8 |
| 8 | Inspect for poor connections at the harness connector of the radio. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS
and CONNECTOR REPAIRS
. Did you find and correct the condition. |
Go to Step 10 | Go to Step 9 |
| 9 | Replace the remote playback device. Refer to Remote CD Player Replacement . Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |