Remote Playback Device - CD Player - Uplevel/Luxury: Notes

In order to operate the Compact Disc player, perform the following steps:

1. Insert a disk part way into the slot, label side up.
2. If the radio is in the OFF position and the ignition is in the ON position when you insert the CD, the radio turns on and begins playing the CD.
3. In order to load a CD with the ignition in the OFF position, press the EJECT button on the remote player and insert the disc.
4. In order to remove the disc, press the EJECT button and remove the disc.
5. All of the compact disc functions are controlled by the radio buttons except EJECT.
6. When a disc is in the player, a CD symbol appears next to the CD symbol in the bottom left corner on the display.

   The track number will also be displayed.

7. If the disc comes back out and ERR appears on the display, inspect for the following conditions:
   • An upside down disc
   • A dirty, scratched, or wet disc
   • Too much moisture in the air

     If there is too much moisture in the air, wait about 1 hour and try again.

   • The vehicle is operating on a very rough road.

TAPE AUX

1. With a disc loaded in the player and the radio playing, press the TAPE AUX button once in order to play the compact disc.
2. Press AM-FM in order to return to the radio.
3. If you load both a cassette and a CD, press TAPE AUX in order to switch between the tape and the compact disc.

SEEK

1. Press the left arrow while playing a CD in order to go back to the beginning of the current track.
2. The CD goes back to the current track if more than 8 seconds have played.
3. Press the left arrow again in order to go to the previous tracks.
4. Press the right arrow in order to go to the next higher track on the disc.

PREV

1. Press PREV in order to go back to the beginning of a current track.
2. The CD goes back to the current track after 8 seconds have played.
3. Press PREV again in order to go the previous track on the disc.