LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Compressor Replacement (L18 w/Harrison) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Add the proper amount of PAG oil to the compressor crankcase. Refer to Refrigerant System Capacities .
  2. Install the A/C compressor drain plug. Tighten the drain plug to 20 N.m (15 lb ft).
  3. Install the A/C compressor to the mounting bracket.

    Important:  Insert the mounting bolt into the lower right mounting bracket before installing the A/C compressor.

  4. Install the 3 A/C compressor mounting bolts. Tighten the bolts to 50 N.m (37 lb ft).
  5. Connect the electrical connection.
  6. Install the A/C compressor hose assembly to the compressor using new sealing washers.
  7. Install the A/C compressor hose assembly bolt to the A/C compressor. Tighten the bolt to 34 N.m (25 lb ft).
  8. Install the right wheel house panel.
  9. Install the right front tire and wheel assembly.
  10. Lower the vehicle.
  11. Install the A/C drive belt.
  12. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery & Recharging .
  13. Leak test the fittings of the component using the J 39400-A  .
scientia non olet · About LEMON Manuals