LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key to the OFF position.
  2. Remove the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
  3. Remove the connector position assurance (CPA) and disconnect the wiper motor electrical connector.
  4. Remove the 3 screws (1) that secure the cover (5) to the wiper motor (2) and remove the cover.
    5. IMPORTANT: If sealant was found on the old cover, it will be necessary to remove any old sealant from the motor housing.
  5. Inspect for sealant on the inside of the cover and then discard the cover and screws (1).
  6. Carefully remove the module (4) (circuit board) from the wiper motor by lifting up on the end of the module electrical connector (3).
    Fig 1: Wiper Motor Cover & Module
    GM1510182Courtesy of GENERAL MOTORS CORP.
  7. If necessary, remove any old sealant from the wiper motor housing.
scientia non olet · About LEMON Manuals