LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the wiper arm to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
    Fig 1: Rear Wiper Arm Components
    GM632379Courtesy of GENERAL MOTORS CORP.
  2. Install the nut retaining the wiper arm to the wiper motor.

    Tighten:  Tighten the nut to 23 N.m (17 lb ft).

  3. Swivel the wiper arm cover closed.
  4. Connect the washer hose to the wiper arm.
  5. Check the rear wiper for proper operation.
scientia non olet · About LEMON Manuals