LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump/Reservoir Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery and battery tray from the vehicle. Refer to BATTERY TRAY REPLACEMENT .
  2. Remove the inner wheel housing from the vehicle. Refer to WHEELHOUSE PANEL REPLACEMENT .
  3. Disconnect the electrical connector from the washer pump.
  4. Disconnect the electrical connector from the washer solvent level sensor.
  5. Disconnect the washer hose from the washer pump.
  6. Remove the upper bolt from the washer solvent container.
    Fig 1: Washer Solvent Container Upper Bolt
    GM346934Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower bolts from the washer solvent container.
    Fig 2: Washer Solvent Container Lower Bolts
    GM346938Courtesy of GENERAL MOTORS CORP.
  8. Remove the washer solvent container from the vehicle.
scientia non olet · About LEMON Manuals