LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 675 (Wiper System & Washer System) >> Repair Instructions >> Washer Pump/Reservoir Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the washer solvent container into the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
    Fig 1: Washer Solvent Container Lower Bolts
    GM346938Courtesy of GENERAL MOTORS CORP.
  2. Install the lower bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: Washer Solvent Container Upper Bolt
    GM346934Courtesy of GENERAL MOTORS CORP.
  3. Install the upper bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Connect the electrical connector to the washer pump.
  5. Connect the electrical connector to the washer solvent level sensor.
  6. Connect the washer hose to the washer pump.
  7. Install the inner wheel housing. Refer to WHEELHOUSE PANEL REPLACEMENT .
  8. Install the battery and battery tray. Refer to BATTERY TRAY REPLACEMENT .
scientia non olet · About LEMON Manuals