LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 674 (Engine Cooling System) >> Repair Instructions >> Water Pump Replacement (8.1L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump & Gasket
    GM470790Courtesy of GENERAL MOTORS CORP.
  1. Place NEW water pump gaskets into place.
  2. Install the water pump.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the water pump bolts.

    Tighten:  Tighten the water pump bolts to 50 N.m (37 lb ft).

    4. Fig 2: Thermostat Bypass Hose & Clamps
    GM470692Courtesy of GENERAL MOTORS CORP.
  4. Install the bypass hose.
  5. Position the bypass hose clamps at the water pump and water crossover.
    6. Fig 3: Identifying Outlet Hose To The Water Pump
    GM751427Courtesy of GENERAL MOTORS CORP.
  6. Install the outlet hose to the water pump.
  7. Position the outlet hose clamp at the water pump.
  8. Install the fan clutch. Refer to Fan Clutch Replacement .
  9. Install the drive belt. Refer to DRIVE BELT REPLACEMENT -- ACCESSORY .
  10. Fill the cooling system. Refer to Draining and Filling Cooling System .
scientia non olet · About LEMON Manuals