LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Replacement - Auxiliary >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Battery Hold Down Retainer & Bolt
    GM662956Courtesy of GENERAL MOTORS CORP.
  1. Install the battery insulator, if necessary.
  2. Install the auxiliary battery.
    NOTE: Refer to FASTENER NOTICE .
  3. Install battery hold down retainer and bolt.

    Tighten:  Tighten the battery hold down retainer bolt to 25 N.m (18 lb ft).

    4. Fig 2: Auxiliary Battery
    GM662692Courtesy of GENERAL MOTORS CORP.
  4. Connect the auxiliary positive battery cable.

    Tighten:  Tighten the auxiliary positive battery cable bolt to 17 N.m (13 lb ft).

  5. Snap the auxiliary positive battery cable cap closed.
    6. Fig 3: View of Battery Ground Negative Cable
    GM662415Courtesy of GENERAL MOTORS CORP.
  6. Connect the auxiliary negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .
scientia non olet · About LEMON Manuals