LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 672 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Relay Replacement - Auxiliary >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Auxiliary Battery Relay & Nuts
    GM663473Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the auxiliary battery relay.
  2. Install the auxiliary battery relay nuts.

    Tighten:  Tighten the auxiliary battery relay nuts to 9 N.m (80 lb in).

  3. Fig 2: View Of Auxiliary Battery Relay, MAF, IAT & Coolant Level Sensor Electrical Connectors
    GM674702Courtesy of GENERAL MOTORS CORP.
  4. Connect the auxiliary battery relay electrical connector (1).
  5. Fig 3: View of Auxiliary Battery Positive Cable
    GM662684Courtesy of GENERAL MOTORS CORP.
  6. Install the auxiliary battery positive cable to the auxiliary battery relay.
  7. Install the auxiliary battery positive cable nut.

    Tighten:  Tighten the auxiliary positive cable nut to 9 N.m (80 lb in).

  8. Position the boot to cover the stud.
  9. Fig 4: Auxiliary Battery
    GM662692Courtesy of GENERAL MOTORS CORP.
  10. Install the auxiliary battery positive cable to the auxiliary battery relay.
  11. Install the auxiliary battery positive cable nut.

    Tighten:  Tighten the auxiliary positive cable nut to 9 N.m (80 lb in).

  12. Position the boot to cover the stud.
  13. Fig 5: View of Battery Ground Negative Cable
    GM662415Courtesy of GENERAL MOTORS CORP.
  14. Connect the auxiliary negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery)  or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) .