LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Wiring Harness Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
    2. Fig 1: Removing Liftgate Wiring Harness
    GM577905Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the window defogger wiring connectors.
  3. Disconnect the key switch connector.
  4. Disconnect the window ajar switch connector.
  5. Disconnect the wiper module connector.
  6. Disconnect the door lock actuator connector.
  7. Disconnect the door ajar switch connector(s).
  8. Remove the wiring harness clips.
  9. Pull back the rubber boot on door side grommet to expose plastic snap ring
  10. Release the snap ring locks.
  11. Remove the wiring harness from door.
scientia non olet · About LEMON Manuals