LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Wiring Harness Replacement - Door (Cargo Door) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Door Wiring Harness (Cargo Door)
    GM577898Courtesy of GENERAL MOTORS CORP.
  1. Install the wiring harness to the door.
  2. Connect the key switch connector (RHS only).
  3. Connect the door ajar switch connectors.
  4. Install the wiring harness clips.
  5. Connect the power door lock actuator connector (RHS only).
  6. Connect the window defogger wiring connectors.
  7. Connect the door wiring contact connector(s).
    8. NOTE: Refer to FASTENER NOTICE .
  8. Install the door wiring contact screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  9. Install the trim panel. Refer to Trim Panel Replacement - Rear Door .
scientia non olet · About LEMON Manuals