LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Rear Door >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Apply the weatherstrip in an environment that is free from dust or dirt that could come into contact with the adhesive backing. Foreign material may cause improper adhesion.
    Fig 1: Removing Rear Door Weatherstrip
    GM277873Courtesy of GENERAL MOTORS CORP.
  1. Install the weatherstrip to the mounting surface by completing the following steps:
    1. Peel off the backing paper.
    2. Press the retainers into place.
  2. Close the door.
scientia non olet · About LEMON Manuals