Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Starting from one end of the weatherstrip, install the weatherstrip.
- Ensure the corners of the weatherstrip are fully seated.
- Install the floor hinge molding.
- Close the midgate.
- Install the rear removable rear glass panel.
- Inspect the weatherstrip when the midgate is closed and the glass panel installed.
- Set the rear seat in the upright position.
IMPORTANT:
To begin the installation of the weatherstrip, ensure the weatherstrip is at a minimum of 21°C (70°F).