LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Spoiler Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Be careful not to scratch or chip the paint.
    Fig 1: Rear Spoiler
    GM827106Courtesy of GENERAL MOTORS CORP.
  1. Heat the spoiler using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

    Apply heat using a circular motion for about 30 seconds.

  2. Starting from one end of the spoiler, peel off the Endgate surface using a flat-bladed tool.
  3. Remove all adhesive from the body panel using a 3M™ stripe off wheel # 07498 or equivalent.
scientia non olet · About LEMON Manuals