Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
- Dry the area thoroughly.
- Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or heat gun.
- Ensure the spoiler is at a minimum temperature of 16°C (60°F).
If the temperature of the molding is below 16°C (60°F), warm up spoiler with a heat lamp or heat gun.
- Remove the protective tape.
- Without allowing the adhesive surface to touch the endgate, ensure the molding is aligned.
- Install as shown in side view.
- Press on the molding in order to install to the body.
IMPORTANT:
Apply the molding in an environment free of dust and dirt. Dust and dirt could come in contact with the adhesive surface and prevent proper adhesion.
IMPORTANT:
Do not touch the adhesive surface when the tape is removed.