LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Rear Body Opening Frame Load Floor Grate Drain Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Body Opening Frame Load Floor Grate Drain Valve
    GM804457Courtesy of GENERAL MOTORS CORP.
  1. Install the front drain valve into the floor.
  2. Press down on the front drain valve using firm pressure to firmly seat the valve into the floor.
  3. Install the load floor grate. Refer to Grate Replacement - Load Floor Water Management (Avalanche) .
  4. Install the compartment covers.
  5. Close the end gate.
scientia non olet · About LEMON Manuals