LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement (Utility) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Pressure Relief Valve
    GM800703Courtesy of GENERAL MOTORS CORP.
  1. Install the pressure relief valve.
  2. Press the pressure relief valve to fully seat.
  3. Install the upper rear garnish molding. Refer to GARNISH MOLDING REPLACEMENT - REAR CORNER .
    4. Fig 2: Installing Outer Quarter Panel Upper Applique
    GM521810Courtesy of GENERAL MOTORS CORP.
  4. Install the outer quarter panel upper applique.
  5. Close the lift gate.
scientia non olet · About LEMON Manuals