LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement (Avalanche/Escalade Ext) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressure Relief Valve (Avalanche/Escalade Ext)
    GM800702Courtesy of GENERAL MOTORS CORP.
  1. Install the pressure relief valve ensuring a snap fit.
  2. Install the cargo box bridge side outer panel. Refer to PANEL REPLACEMENT - CARGO BOX BRIDGE SIDE OUTER (AVALANCHE) .
  3. Install the cargo box bridge side inner panel. Refer to PANEL REPLACEMENT - CARGO BOX BRIDGE SIDE INNER (AVALANCHE/EXT) .
  4. Install the cargo box bridge center bar. Refer to PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (AVALANCHE) or PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (ESCALADE EXT) .
  5. Install the rear side drain duct deflector. Refer to DEFLECTOR REPLACEMENT - BODY SIDE REAR DRAIN .
  6. Replace the rear compartment assembly(s).
  7. Close the end gate.
scientia non olet · About LEMON Manuals