LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Endgate (Tahoe/Yukon Adjustment)

Lock Striker Replacement - Endgate (Tahoe/Yukon Adjustment)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear sill plate trim panel. Refer to Door Protector Replacement - Rear .
  2. Loosen the striker bolts.
    3. Fig 1: Endgate Lock Striker (Tahoe/Yukon Adjustment)
    GM570305Courtesy of GENERAL MOTORS CORP.
  3. Move the assembly, forward or backward, in order to obtain the proper close of the liftgate.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Ensure that the endgate seals completely with the minimum closing effort.

    Tighten:  Tighten the striker assembly to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals