LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Lock Rod and Outside Handle Replace - Rear Door >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel, as necessary. Refer to Trim Panel Replacement - Rear Door .
  2. Pull back the water deflector, as necessary. Refer to Water Deflector Replacement .
    3. Fig 1: Rear Door Lock Rod & Outside Handle
    GM570292Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the lock cylinder rod from the rod clip.
  4. Remove the outside handle nuts.
  5. Remove the outside handle.
  6. Disconnect electrical connector if required.
  7. Remove actuator cable.
  8. Remove the door lock cylinder. Refer to LOCK CYLINDER REPLACEMENT - DOOR .
  9. Complete the necessary procedures:
scientia non olet · About LEMON Manuals