LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Lock Actuator Replacement - Door (Liftgate) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper and lower trim panels. Refer to Trim Panel Replacement - Liftgate .
  2. Disconnect the electrical connectors.
  3. Remove the cables attached to actuator assembly.
    4. Fig 1: Door Lock Actuator (Liftgate)
    GM570312Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolts from the latch actuator.
  5. Remove the actuator from the liftgate.
  6. Remove the liftgate lock cylinder. Refer to Lock Cylinder Replacement - Liftgate .
scientia non olet · About LEMON Manuals