LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Lock Actuator Replacement - Door (Cargo Door) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cargo door trim panel, as necessary. Refer to Trim Panel Replacement - Rear Door .
  2. Pull back the water deflector, as necessary. Refer to Water Deflector Replacement .
    3. Fig 1: Door Lock Actuator (Cargo Door)
    GM570302Courtesy of GENERAL MOTORS CORP.
  3. Remove the actuator lock control rod.
  4. Disconnect the actuator wiring connector.
  5. Remove the handle actuating cable.
  6. Remove latch actuator cable.
  7. Remove the bolts that retain the actuator assembly to the door.
  8. Remove the actuator from the cargo door.
scientia non olet · About LEMON Manuals