Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Endgate Handle Bolts

Courtesy of GENERAL MOTORS CORP.

Lower the endgate.
Loosen the endgate handle bolts. Refer to Handle Replacement - Endgate (Avalanche) .
Raise the endgate.

Fig 2: Endgate Handle Bezel

Courtesy of GENERAL MOTORS CORP.

Remove the handle bezel by prying gently on the upper retainer tabs.
Lower and support the endgate.
Remove the endgate latch assembly. Refer to Latch Replacement - Endgate .

Fig 3: Linkage Rod & Latch Assembly

Courtesy of GENERAL MOTORS CORP.

Disengage the linkage rod from the latch assembly.

Fig 4: Handle Linkage Rods

Courtesy of GENERAL MOTORS CORP.

Remove the linkage rod (1) from the endgate handle assembly.