LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Latch Control Handle Replacement - Left Rear Door >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Rear Door Latch Control Handle
    GM570296Courtesy of GENERAL MOTORS CORP.
  1. Connect the upper latch cable.
  2. Install the latch control handle.
  3. NOTE: Refer to FASTENER NOTICE .
  4. Install the latch control handle screws.

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

  5. Connect the lower latch cable to handle.
  6. Pull back the water deflector, as necessary. Refer to Water Deflector Replacement .
  7. Install the rear door trim panel, as necessary. Refer to Trim Panel Replacement - Rear Door .