Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Placing Lower Hinge Studs Into Stowage Compartment

Courtesy of GENERAL MOTORS CORP.

Place the lower hinge studs (1) into the stowage compartment (2).

Fig 2: Installing Lower Hinge Retainers

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: If equipped with a gasket, ensure the gasket alignment surrounds the retainers to prevent water intrusion.

Install the lower hinge retainers (1).

Fig 3: Installing Upper Hinge Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Align the upper hinge with the stowage compartment lid and install the screws (1).
Tighten: Tighten the screws to 7 N.m (62 lb in).
Reinstall the stowage compartment onto the vehicle. Refer to Lid Replacement - Cargo Box Stowage Box (Avalanche) .