LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Endgate Adjustment

Endgate Adjustment

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the end gate.
    2. Fig 1: End Gate Handle Bezel Retaining Bolts
    GM814590Courtesy of GENERAL MOTORS CORP.
  2. Remove the end gate handle bezel retaining bolts (1).
    3. Fig 2: Removing End Gate Handle Bezel
    GM814585Courtesy of GENERAL MOTORS CORP.
  3. Remove the end gate handle bezel (2) by using a flat-bladed tool to release the push-in retainers attached to the bezel directly below the handle (3).
    4. Fig 3: Releasing Right Side End Gate Handle Latch Rod Retainer
    GM814588Courtesy of GENERAL MOTORS CORP.
  4. Release the right side end gate handle latch rod retainer (3).
    5. Fig 4: Releasing Left Side End Gate Handle Latch Rod Retainer
    GM814586Courtesy of GENERAL MOTORS CORP.
  5. Release the left side end gate handle latch rod retainer (4).
  6. Adjust the latch by positioning the rod seating position in the retainer. Position each side equally.
  7. Attach the retaining clips.
  8. Close the end gate. Ensure that the end gate is latched securely.
  9. Open the end gate. Observe the ease of operation.
  10. Continue to adjust by repeating steps 6 through 9 until the desired operation is achieved.
    11. NOTE: Refer to FASTENER NOTICE .
  11. Attach the end gate handle bezel. Ensure that both push-in retainers are aligned correctly.

    Tighten:  Tighten the bolts to 9 N.m (7 lb ft).

scientia non olet · About LEMON Manuals