LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Door Striker Replacement - Body Mounted Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Body Mounted Rear Door Striker
    GM570308Courtesy of GENERAL MOTORS CORP.
  1. Install the striker to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the striker screws.

    Tighten:  Tighten the screws to 25 N.m (18 lb ft).

  3. Install the upper garnish trim panel. Refer to Garnish Molding Replacement - Rear Door Frame .
scientia non olet · About LEMON Manuals