LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Body Rear End) >> Repair Instructions >> Door Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper and lower hinge pin retainer clips to the hinge.
    2. Fig 1: Installing Roller Assembly Bolts To Upper Door Side Hinge
    GM572299Courtesy of GENERAL MOTORS CORP.
  2. Install the bolts on the roller assembly to the upper door side hinge.
    3. Fig 2: Installing Rear Door
    GM572307Courtesy of GENERAL MOTORS CORP.
  3. With an assistant, position the door to the vehicle.
  4. Install a bolt through the lower hinge pin holes.
  5. Using a soft-faced hammer and a pair of locking pliers, install the upper hinge pin with the pointed end of the pin pointing upward.
  6. Remove the temporary bolt from the lower hinge.
  7. Install the lower hinge pin with the pointed end of the pin pointing downward.
  8. Remove the cloth-backed tape from the door and the body pillar.
  9. Install the taillamps. Refer to TAIL/TURN SIGNAL LAMP REPLACEMENT .
  10. Install the check assembly hinge pin with the pointed end of the pin pointing downward.
  11. Connect the negative battery cable, as necessary on vehicles with power components. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) or BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (AUXILIARY BATTERY) .
scientia non olet · About LEMON Manuals