LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 670 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Testing for Short to Ground >> With a DMM

With a DMM

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power feed (i.e. fuse, control module) from the suspect circuit.
  2. Disconnect the load.
  3. Set the rotary dial of the DMM to the Ω position.
  4. Connect 1 lead of the DMM to 1 end of the circuit to be tested.
  5. Connect the other lead of the DMM to a good ground.
  6. If the DMM does NOT display infinite resistance (OL), there is a short to ground in the circuit.
scientia non olet · About LEMON Manuals