LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Electronic Suspension System - Real Time Damping (RTD)) >> Repair Instructions >> Front Position Sensor Replacement - Electronic Suspension (25 Series 4WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Disconnect the sensor harness connector from the vehicle harness connector.
  3. Remove the wheel speed sensor wire from the real time damping (RTD) sensor bracket.
  4. Remove the RTD sensor link bracket bolt from the upper control arm.
  5. Remove the bolt from the frame.
  6. Remove the position sensor from the vehicle.
    Fig 1: Removing Front Position Sensor (25 Series 4WD)
    G01662908Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals