LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Electronic Suspension System - Real Time Damping (RTD)) >> Repair Instructions >> Front Position Sensor Link Assembly Replacement - Electronic Suspension >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not attempt to pry the link rod from the real time damping (RTD) ball stud. If the link rod needs to be replaced or disconnected you must use the following procedure.

  1. Remove the RTD sensor from the vehicle. Refer to Front Position Sensor Replacement - Electronic Suspension (15 Series)  or Front Position Sensor Replacement - Electronic Suspension (25 Series 2WD)  or Front Position Sensor Replacement - Electronic Suspension (25 Series 4WD) .
  2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
  3. Remove the link rod from the mounting bracket ball stud.
scientia non olet · About LEMON Manuals