LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 668 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Escalade EXT) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the headlamp switch is in the OFF position.
  2. Remove the rear compartment cover assembly.
  3. Remove the cargo box bridge center bar. Refer to PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (AVALANCHE) or PANEL REPLACEMENT - CARGO BOX BRIDGE CENTER (ESCALADE EXT) .
    4. Fig 1: Stoplamp Retaining Screws
    G01696793Courtesy of GENERAL MOTORS CORP.
  4. Remove the stoplamp retaining screws.
    5. Fig 2: Electrical Connector
    G01696794Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector (1).
    6. Fig 3: High Mounted Stop Lamp Assembly
    G01696795Courtesy of GENERAL MOTORS CORP.
  6. Remove the lamp assembly from the cargo box bridge center bar.
scientia non olet · About LEMON Manuals