LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Rear (60/40 - 50/50 Split) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the buckle and the latch to the seat frame.
    2. Fig 1: Rear Seat Belt Buckle
    GM768629Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the buckle bolts.

    Tighten:  Tighten the bolts to 55 N.m (41 lb ft).

  3. Connect the seat cushion cover by joining the cushion trim J-strips.
    4. Fig 2: Handle Mounting Screws
    GM768627Courtesy of GENERAL MOTORS CORP.
  4. Install the handle mounting screws (1).

    Tighten:  Tighten the screws to 7 N.m (61 lb in).

  5. Install the seat back frame. Refer to SEAT BACK FRAME REPLACEMENT - REAR (60/40 - 50/50 SPLIT) or SEAT BACK FRAME REPLACEMENT - REAR (BENCH) .
    6. Fig 3: Seat Belt Retractor Bolt Cover & Mounting Bolts
    GM768626Courtesy of GENERAL MOTORS CORP.
  6. Install the retractor mounting bolt (2).

    Tighten:  Tighten the bolt to 55 N.m (410 lb ft).

  7. Install the seat belt retractor bolt cover (1).
  8. Install the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR (60/40 - 50/50 SPLIT) or SEAT BACK COVER AND PAD REPLACEMENT - REAR (BENCH) .
  9. Install the headrests. Refer to HEAD RESTRAINT REPLACEMENT (NON-CADILLAC) or HEAD RESTRAINT REPLACEMENT (CADILLAC) or HEAD RESTRAINT REPLACEMENT (FOLDING) .
    10. Fig 4: Seat Belt Anchor Screw
    GM768625Courtesy of GENERAL MOTORS CORP.
  10. Install the seat belt anchor screw (1) to the cushion frame.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft)

    11. Fig 5: Latch Cover
    GM768624Courtesy of GENERAL MOTORS CORP.
  11. Install the latch cover (1) to the seat.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  12. In order to secure the seat back, manually rotate the center latch. Rotate the latch until the seat back clicks into position.
  13. Install the seat to the vehicle. Refer to SEAT REPLACEMENT - REAR (60/40 SPLIT) or SEAT REPLACEMENT - REAR (50/50 SPLIT 2ND REAR) .
scientia non olet · About LEMON Manuals