LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Tahoe/Yukon/Escalade/Suburban) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door sill plate. Refer to DOOR SILL PLATE REPLACEMENT - FRONT or DOOR SILL PLATE REPLACEMENT - REAR .
  2. Remove the lower anchor bolt from bodyside panel.
  3. Remove the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE/YUKON/ESCALADE/SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE/ESCALADE EXT) .
  4. Route the belt through trim panel.
    5. Fig 1: View Of Seat Belt Retractor - No. 1 Rear (Tahoe/Yukon/Escalade/Suburban)
    GM610728Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt from the upper guide.
  6. Remove the bolt from the retractor.
  7. Remove the seat belt anchor bolt cover.
  8. Remove the floor anchor bolt.
  9. Remove the assembly from the vehicle.
scientia non olet · About LEMON Manuals