LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Tahoe/Yukon/Escalade/Suburban) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the assembly to vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the bolt to the retractor.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  3. Install the bolt to the upper guide.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

    4. Fig 1: View Of Seat Belt Retractor - No. 1 Rear (Tahoe/Yukon/Escalade/Suburban)
    GM610728Courtesy of GENERAL MOTORS CORP.
  4. Route the belt through trim panel.
  5. Install the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE/YUKON/ESCALADE/SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE/ESCALADE EXT) .
  6. Install the lower anchor bolt to bodyside panel.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  7. Install the floor anchor bolt.

    Tighten:  Tighten the bolt to 55 N.m (41 lb ft).

  8. Install the seat belt anchor bolt cover.
  9. Install the door sill plate. Refer to DOOR SILL PLATE REPLACEMENT - FRONT or DOOR SILL PLATE REPLACEMENT - REAR .
scientia non olet · About LEMON Manuals