LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Rear (Avalanche/Escalade EXT) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Belt Retractor - No. 1 Rear (Avalanche/Escalade EXT)
    GM741389Courtesy of GENERAL MOTORS CORP.
  1. Fold the rear seat down.
  2. Remove the rear floor door sill. Refer to DOOR SILL PLATE REPLACEMENT - REAR .
  3. Remove the rear removable glass panel.
  4. Remove the seat belt anchor cover.
  5. Remove the third pillar trim panel. Refer to TRIM REPLACEMENT - THIRD PILLAR (TAHOE/YUKON/ESCALADE/SUBURBAN) or TRIM REPLACEMENT - THIRD PILLAR (AVALANCHE/ESCALADE EXT) .
  6. Remove the seat belt anchor retaining bolt.
  7. Route the seat belt through the opening in the pillar trim panel.
  8. Remove the seat belt retractor bolt.
  9. Remove the rear seat belt assembly from the vehicle.
scientia non olet · About LEMON Manuals