LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - No. 2 Rear (60/40 Split - 50/50 Split) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the buckle to the seat frame.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the buckle bolts.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft).

    Fig 1: View of No. 2 Rear Seat Belt Buckle (60/40 Split - 50/50 Split)
    GM768629Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Handle Mounting Screws
    GM768627Courtesy of GENERAL MOTORS CORP.
  3. Connect the seat cushion cover by joining the cushion J-strips.
  4. Install the handle mounting screws.

    Tighten:  Tighten the screws to 7 N.m (61 lb in).

scientia non olet · About LEMON Manuals