LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Transfer Case - NVG 261-NP2 (2-Speed Manual)) >> Repair Instructions >> Transfer Case Control Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transfer case shift lever control mounting bolts.
  2. Install the transfer case control lever mounting bolts. Tighten the transfer case control lever mounting bolts to 2 N.m (18 in lbs).
  3. Install the transfer case control lever bezel to the floor panel.
  4. Install the transfer case control lever bezel mounting screws. Tighten the transfer case control lever bezel screws to 2 N.m (18 in lbs).
  5. Install the transfer case control lever knob.
  6. Raise the vehicle.

    Important:  When performing the following service procedure, make sure that the shift rod is firmly seated on the shift control lever. A snap should be heard or felt when installing shift rod. If the snap is not heard or felt, replace the shift rod.

  7. Reconnect the shift rod to the shift control lever.
  8. Install the front propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - FRONT .
  9. Install the transfer case shield. Refer to Transfer Case Fluid Replacement .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals