Conditions for Setting the DTC
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The transfer case shift control module detects continued readings of front and rear propshaft speed signal which do not match. The module is unable to determine propshaft speed.
The system will log the DTC if the front and rear propshaft inputs indicates a speed greater than 20% difference for 40 seconds while all of the following are true:
- Transmission NOT in Park/Neutral
- Engine is running
- Front axle is engaged
- Front Propshaft indicates speed less than 75 mph
- Front Propshaft or Rear Propshaft speed exceeds 512 RPM
- Vehicle Speed On Class 2 Data bus exceeds 16 km/h (10 mph)