LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 660 (Wiring Systems (General Information)) >> Repair Instructions >> Body Wiring Harness Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wire harness block to the junction block.
  2. Install the retaining bolts. Tighten the bolts to 6 N.m (53 in lbs).
  3. Install the junction block to the bracket.
  4. Push on the top part until it clicks in place.
  5. Connect the harness to the front of the junction block.
  6. Install the cover to the junction block until it clicks in place.
  7. Hand tighten the retaining nut until seated.
scientia non olet · About LEMON Manuals