LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 658 (Wiring Systems (General Information)) >> Repair Instructions >> Relay Replacement (Attached To Wire Harness) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the relay. Refer to the BUZZERS, RELAYS & TIMERS .
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.

    Important:  Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.

  4. Separate the relay (1) from the wire harness connector (2).
    Fig 1: Identifying Wire Harness Mounted Relay
    G01754668Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals