LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 656 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear compartment latch striker.
  2. Install the nuts in order retain the latch striker.
    CAUTION: Refer to FASTENER NOTICE .
  3. Adjust the rear compartment latch striker as necessary.

    Tighten 

    Tighten the latch striker nuts to 9 N.m (80 lb in).

  4. Install the rear fascia. Refer to FASCIA REPLACEMENT -- REAR BUMPER .
  5. Install the rear compartment sill plate. Refer to Compartment Sill Plate Replacement - Rear  .
    Fig 1: Installing Rear Compartment Latch Striker
    G01804061Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals