LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 650 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Trip Odometer and Reset Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the IP cluster trim plate. Refer to Trim Plate Bezel Replacement - IP Cluster  .
  2. Disconnect the electrical connector from the trip reset switch.
  3. Remove the trip reset switch that is located to the left of the steering column, by pressing tab (1) at the top from behind in order to push out through the front of the IP cluster trim plate bezel.
    Fig 1: Removing Trip Reset Switch
    G01803054Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals