LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Engine Mechanical - 6.6L (On-Vehicle)) >> Removal & Installation >> Valve Rocker Arm Covers >> Installation (Lower Left)

Installation (Lower Left)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install lower valve rocker arm cover gasket in lower valve rocker arm cover, and bolt grommets in lower valve rocker arm cover. Install lower valve rocker arm cover.
  2. Install 12 bolts for lower valve rocker arm cover. The lower valve rocker arm cover is tightened 2 times in numerical order. Bolts No. 1 and 2 are used to position cover. Tighten lower valve rocker arm cover bolts to 89 INCH lbs. (10 N.m) in proper sequence. Retighten lower valve rocker arm cover bolts to 89 INCH lbs. (10 N.m) in proper sequence. See Figure.
  3. Install injector harnesses. Install injector harness bracket bolts. Install injector wire terminals and nuts to injectors. Connect injector wiring harnesses connectors. Install upper left valve rocker arm cover.
scientia non olet · About LEMON Manuals